Available For The QMark
Baseboard Heater HBB Models
25 amp at 120-277 Single Pole Thermostat HBBT1: Single
pole thermostats break only one side of the power line to your heater and cannot
be turned ''off.'' Therefore, power is continuous to the heater even if it is
not running. The control knob will have a low temperature setting without an
''off'' position. These thermostats generally have a temperature range of 40 to
90 degrees. The thermostat attaches in the end cap of the heater.
Duplex Receptacle 15 amps at 120 VAC HBBDR: An optional
accessory that attaches and makes an additional two plug outlets for any baseboard heater.
This accessory will add 8 inches to the length of the baseboard heater as it
attaches to the end cap of the heater.
25 amp at 120-277 VAC Double Pole Thermostat HBBT20: A
"Double Pole" is an older term for a switch that allows you to turn both sides
of the filament on and off - actually turning it completely off making it much
safer than leaving it always energized. Double pole thermostats should be used
for zonal heat systems such as electric fan heaters, baseboard heaters, and
radiant heaters. This thermostat attached within the end cap.
Two Pole Tamper-Proof Thermostat: A standard two pole
thermostat but with a tamper proof guard that resembles a small disc covering,
which is only removable with a screwdriver. Once it is off, an inside stem is
clearly visible. This is then rotated with a screwdriver or with your fingers.
This thermostat attached within the end cap.
Inside Corner CBDCIC: Allows two baseboard heaters to be
set up next to each other on walls that are at a right angle to each other. If
you were standing in the corner, the point of the corner would point away from
Outside Corner CBDCOC: If you were facing the point of
this corner, it would be pointing towards you.
AC Outlet 20 Amps at 208/240 VAC HBBAC: This accessory
enables you to install a 240 volt 20 amp outlet to your baseboard heater.